Test stand for hydraulic switches

Tester for hydraulic switches with a defined width across flat. The various connecting threads and switch lengths are balanced by a binary coded adapter. Specific probes are used for the various insulated parts and testing steps (preliminary testing, final testing) in the binder.

After successful preliminary testing, the components are fixed in the housing via two cylinders.

The function check takes place using a small hydraulic unit and a hydraulic proportional valve used to travel the specified pressure edge. The switching point is detected in analog or digital format and the contact resistance is measured.

Pressure range:
0 – 30bar

Mark:
Good part is marked with cold stamping (point).

Control:
Industrial PC

Production location:
Czech Republic

2018-04-19T15:02:08+00:00